Scooterotica

Now got some wired exhaust nuts and am about to refit the exhaust, so just need to know is there a certain way to wire up the nuts or do i just feed it through both nuts and wind it up with a pair of grips?

Did mine in a figure of eight on one side of manifold - if that makes sense! (I mean don't do it in a loop around the manifold)

Luckily thats the way ive done it after searching the net for the answer

Thanks for the reply

I'm thinking that figure of eight should be on the rhs of the manifold?

Here's a story I did on the subject a few year's back. There are some good illustrations and stuff that cover your questions. Hope it helps!

http://www.customclassictrucks.com/tech ... ewall.html

Actually thats the article I found using google

Very informative

Why bother with thin wire that snaps??? I just put a small piece of gear cable thru mine with a trunion at each end

^ That's clever.

Second that

Now why didnt I think of that!