My restored GP150 before and after
GP150
- sunrisemac
- registered user
- Posts: 47
- Joined: Mon Oct 06, 2014 10:25 pm
- Main scooter: Lambretta GP150
- Location: Dear Old Sussex by the Sea
- Contact:
- scooterslag
- registered user
- Posts: 410
- Joined: Wed Jan 07, 2009 12:23 pm
- Location: Sunny Barnstaple
- Contact:
Tidy, good work fella!
The mack daddy on the left!
- Scootissimo
- registered user
- Posts: 95
- Joined: Wed Jan 21, 2009 10:17 pm
- Location: IOW
- Contact:
Now, that is a transformation!
But surely not a standard 150 lump?
But surely not a standard 150 lump?
- sunrisemac
- registered user
- Posts: 47
- Joined: Mon Oct 06, 2014 10:25 pm
- Main scooter: Lambretta GP150
- Location: Dear Old Sussex by the Sea
- Contact:
The other bike is a 1931 Francis Barnett I have had for 20 years and I still haven't started to restore it.
The engine in the GP is a standard 1969 sx150, I guess its original engine got blown in the past before I got it into the family in around 1996, I did have to extensively repair the chaincase and attendant bits, weld up the fins on the head, fit a new barrel and piston (the old one had loads of bits knocked off) although I have thoughts of overboring it a bit and fitting an oversize piston at some time. All the other bits are what came with the engine. All the bodywork is original but again extensively repaired, I've got a pic of that lot I will post. then got my buddy to retrim the Guiliari seat that is on the bodywork pic
The frame was basically straight but the forks took a lot of straightening as did the back where number plate fits.
The restoration was written up in Jet Set a few issues ago as 'Restory'.
The engine in the GP is a standard 1969 sx150, I guess its original engine got blown in the past before I got it into the family in around 1996, I did have to extensively repair the chaincase and attendant bits, weld up the fins on the head, fit a new barrel and piston (the old one had loads of bits knocked off) although I have thoughts of overboring it a bit and fitting an oversize piston at some time. All the other bits are what came with the engine. All the bodywork is original but again extensively repaired, I've got a pic of that lot I will post. then got my buddy to retrim the Guiliari seat that is on the bodywork pic
The frame was basically straight but the forks took a lot of straightening as did the back where number plate fits.
The restoration was written up in Jet Set a few issues ago as 'Restory'.
- sunrisemac
- registered user
- Posts: 47
- Joined: Mon Oct 06, 2014 10:25 pm
- Main scooter: Lambretta GP150
- Location: Dear Old Sussex by the Sea
- Contact:
Your comment prompted me to have a look at the 'standard 150 lump'.Scootissimo wrote:Now, that is a transformation!
But surely not a standard 150 lump?
Last week I did a good session or two of porting and fitted big bore exhaust and surprised myself just how much improvement I could make to the engine with a little cash and a decent portion of effort, thanks for the kick.....!
- corrado
- Dealer
- Posts: 2588
- Joined: Thu Jan 08, 2009 1:12 am
- Main scooter: Lambretta GP
- Location: Top of Blackpool Tower
- Contact:
The sort of time scale I'm well familiar with, but I'm just a mere novice, 10 years being my current best offering.sunrisemac wrote:....... I have had for 20 years and I still haven't started to restore it.