Page 1 of 1
Series 2 side panels
Posted: Mon Oct 06, 2014 6:38 pm
by dapper
Is there something that goes between the outer handle and the side panel itself to protect the paintwork? Like a cupped washer or summat?
Re: Series 2 side panels
Posted: Mon Oct 06, 2014 7:14 pm
by DigDug
Re: Series 2 side panels
Posted: Mon Oct 06, 2014 8:46 pm
by wrecklessrobbie
There isn't any thing on mine. No washer. Just the handles. But I don't think it has had any.
They have been off at some point however as some one had resprayed the panels. Not sure this helps.
I am repainting at the moment, by hand.....bizzare but true.
Is there a diagram with part names not just the numbers. I am not sure which bits need rubber washers or grommets etc.
Robbie
Re: Series 2 side panels
Posted: Tue Oct 07, 2014 8:36 am
by DigDug
Re: Series 2 side panels
Posted: Tue Oct 07, 2014 3:12 pm
by dapper
Thanks for the link John (and the photo of front muddy
). Just thought there may have been some sort of protective washer twixt panel and handle to stop paintwork getting scratched.
Re: Series 2 side panels
Posted: Tue Oct 07, 2014 3:33 pm
by wack 63
If the shafts' the same size as a Ser 3 , Scooter Restorations sell a steel wavy washer for early Ser3 's or a nylon one for late models.
Re: Series 2 side panels
Posted: Tue Oct 07, 2014 4:40 pm
by DigDug
dapper wrote:Thanks for the link John (and the photo of front muddy
). Just thought there may have been some sort of protective washer twixt panel and handle to stop paintwork getting scratched.
No worries Mark. You'll be a SII expert by the time you've finished.
