Scooterotica

Young Gun I know picked one of these up at Kettering and wondered if it would suit a standard PX 125 for now until he buys an adaptor to fit on a Malossi T5 172 he's gonna get or can you buy a T5 downpipe?

im sure mb or someone similar do a cheap conversion kit for them, dont hold me to it though

This should do the trick:

http://www.scooter-center.com/en/produc ... FF_KRUMMER

Or this:

http://scootrs.com/moreinfo.cfm?Product_ID=1317

Found this, so hopefully do the job. http://m.ebay.com/itm/321536829968?cmd=VIDESC&gxo=true. Thanks for the other inputs.

I would get the main bracket beefed up a bit , I helped rescue another YoungGun on the A1 , after his Revolver exhaust snapped at the bracket and wrapped around his back wheel, slicing his tyre in half. a combination of good riding, good weather and good luck kept him upright.

On the body or the hanger bracket?

hobospeed wrote:This should do the trick:

http://www.scooter-center.com/en/produc ... FF_KRUMMER

Or this:

http://scootrs.com/moreinfo.cfm?Product_ID=1317

There is one of those in this months scootering , in the new bits section from VE

wack 63 wrote:On the body or the hanger bracket?

it was the bracket on the main chamber.

Ok thanks