Page 1 of 1
Advice Needed
Posted: Mon Jul 14, 2014 5:40 pm
by Blakey43
Hi, building a 166 reed valve engine. Casings & inlet are matched and ported and I'm going to use a Revolver pipe and 28mm dellorto carb open mouthed. Any ideas on jetting, needle position etc?
Re: Advice Needed
Posted: Tue Jul 15, 2014 11:10 am
by GLscoot
Blakey, check this thread out. Although slightly different set up.
http://scooterotica.org/forum/viewtopic.php?f=8&t=30933
Gary
Re: Advice Needed
Posted: Wed Jul 16, 2014 11:58 am
by Blakey43
Cheers
Re: Advice Needed
Posted: Wed Jul 16, 2014 12:00 pm
by Blakey43
Cheers