Handlebar rebuild - what's this bush...?

victor · Sun Jul 06, 2014 5:18 pm

I can't identify no 2 among the parts... Confused....

Sent from my iPhone using Tapatalk

wurzel · Sun Jul 06, 2014 5:37 pm

Throttle and gear bush support mate.
If you need to see an exploded view you can usually find most of the
diagrams on Scooter Restorations site

victor · Sun Jul 06, 2014 5:41 pm

I don't have these in my bush kit from sr...

I have to of the gear change collar bush though:

Where are these supposed to go, as they weren't fitted previously, and where do the pin go...?
Cheers v

Sent from my iPhone using Tapatalk

soulsurfer · Sun Jul 06, 2014 5:47 pm

Parts 1 & 2 are the alternatives as used on late SX & GP for locating the rods in the handlebar ends.

victor · Sun Jul 06, 2014 5:50 pm

Mine look like this:

Suppose I won't need these bushes..?

Sent from my iPhone using Tapatalk

victor · Sun Jul 06, 2014 9:37 pm

Can anyone advise on of this is the right way to fit these washers....?

Sent from my iPhone using Tapatalk

victor · Mon Jul 07, 2014 1:18 pm

Bump

Sent from my iPhone using Tapatalk

Mon Jul 07, 2014 2:56 pm

According to the Innocenti S2 parts book the spring washer is shown as going on first followed by the flat spacing washer.

victor · Mon Jul 07, 2014 9:02 pm

The sticky manual says differently, but it looks odd.... Would love to confirm...

Sent from my iPhone using Tapatalk

victor · Wed Jul 09, 2014 11:40 pm

No one?

Sent from my iPhone using Tapatalk