Advice Needed
-
Blakey43
- registered user
- Posts: 23
- Joined: Tue Jan 14, 2014 10:42 pm
- Main scooter: T5 172
- Location: County Durham
- Contact:
Hi, building a 166 reed valve engine. Casings & inlet are matched and ported and I'm going to use a Revolver pipe and 28mm dellorto carb open mouthed. Any ideas on jetting, needle position etc?
-
GLscoot
- registered user
- Posts: 805
- Joined: Thu Mar 15, 2012 10:05 pm
- Main scooter: Vespa GS150
- Contact:
Blakey, check this thread out. Although slightly different set up.
http://scooterotica.org/forum/viewtopic.php?f=8&t=30933
Gary
http://scooterotica.org/forum/viewtopic.php?f=8&t=30933
Gary