Page 1 of 1
AF Head Cowlings (wide fin)
Posted: Thu Jul 10, 2014 8:15 pm
by davla
Will this cowling fit with a standard cylinder and an AF clubman exhaust? Is specifies it's for a TS1 & Imola but also states that it fits most models.
http://www.scooter-center.com/product/7 ... g*8*8*1*16
Re: AF Head Cowlings (wide fin)
Posted: Thu Jul 10, 2014 9:13 pm
by 10 inch Terror
These cowls are cut around the inlet and exhaust areas to allow room for the bigger exhaust stub and inlet manifold. They should still fit a standard cylinder set up though. If I were you I'd just buy a standard one from a good supplier.
Re: AF Head Cowlings (wide fin)
Posted: Fri Jul 11, 2014 10:32 pm
by davla
Cheers, one on order from AF. Wanna buy a quality TS1 cowling??!!