Page 1 of 1
Reed block options for a 200
Posted: Wed Jul 09, 2014 6:34 pm
by fred shed
Hi,
Looking for a reed block assembly for a GP200 cylinder I'm modifying, the LTH is a bit small and not what I'm looking for and the Atomic needs way to many fins removing for my own liking, are there any others available ?
Cheers,
Fred.
Re: Reed block options for a 200
Posted: Wed Jul 09, 2014 11:18 pm
by camel
Yes the mb shorty...I run one on both my bikes,one on a muggello 225 the other on an iron 200,well designed and work well.But you will have to trim some fins
Re: Reed block options for a 200
Posted: Thu Jul 10, 2014 9:01 am
by tea5ive
I wouldn't worry about trimming fins as its on the cool inlet side plus the nice big lump of ally you are adding as a reedblock will act as a heatsink;-)
Re: Reed block options for a 200
Posted: Thu Jul 10, 2014 4:36 pm
by a.j
tea5ive wrote:I wouldn't worry about trimming fins as its on the cool inlet side plus the nice big lump of ally you are adding as a reedblock will act as a heatsink;-)
Aye. I fitted one of the ATOMIC ones last year & have thrashed the arse off my scoot for 3000 odd miles thus far with NO issues at all. Be aware though you wont be able to use a sponge air filter if on S3, the block pushes it too close to the panel.