Scooterotica

Posted: **Sun Jul 06, 2014 5:18 pm**

I can't identify no 2 among the parts... Confused....

Sent from my iPhone using Tapatalk

Posted: **Sun Jul 06, 2014 5:37 pm**

Throttle and gear bush support mate.
If you need to see an exploded view you can usually find most of the
diagrams on Scooter Restorations site

Posted: **Sun Jul 06, 2014 5:41 pm**

I don't have these in my bush kit from sr...

I have to of the gear change collar bush though:

Where are these supposed to go, as they weren't fitted previously, and where do the pin go...?
Cheers v

Sent from my iPhone using Tapatalk

Posted: **Sun Jul 06, 2014 5:47 pm**

Parts 1 & 2 are the alternatives as used on late SX & GP for locating the rods in the handlebar ends.

Posted: **Sun Jul 06, 2014 5:50 pm**

Mine look like this:

Suppose I won't need these bushes..?

Sent from my iPhone using Tapatalk

Posted: **Sun Jul 06, 2014 9:37 pm**

Can anyone advise on of this is the right way to fit these washers....?

Sent from my iPhone using Tapatalk

Posted: **Mon Jul 07, 2014 1:18 pm**

Bump

Sent from my iPhone using Tapatalk

Posted: **Mon Jul 07, 2014 2:56 pm**

According to the Innocenti S2 parts book the spring washer is shown as going on first followed by the flat spacing washer.

Posted: **Mon Jul 07, 2014 9:02 pm**

The sticky manual says differently, but it looks odd.... Would love to confirm...

Sent from my iPhone using Tapatalk

Posted: **Wed Jul 09, 2014 11:40 pm**

No one?

Sent from my iPhone using Tapatalk

Handlebar rebuild - what's this bush...?