Page 1 of 1
200 cylinder head
Posted: Tue Jun 03, 2014 8:44 pm
by sjc
was thinking of fitting a new cylinder head on my mates cast iron stage four,,,wot would people recommend .....cheers steve
Re: 200 cylinder head
Posted: Tue Jun 03, 2014 9:13 pm
by Doom Patrol
An Indian one. Apparently the casting is thicker and they are less prone to warping, or something.
Re: 200 cylinder head
Posted: Tue Jun 03, 2014 9:23 pm
by sjc
no compression issues with indian ones? was looking to get a reworked one from af..........
Re: 200 cylinder head
Posted: Tue Jun 03, 2014 11:15 pm
by kevspeed
No problems at all with S.I.L heads,as in previous post,nice thick casting,i have S.I.L heads on Mrs kevspeeds stage 4,my TS1,and my AF 250.
Re: 200 cylinder head
Posted: Wed Jun 04, 2014 12:35 am
by rosscla
reworked one from AF will be indian
Re: 200 cylinder head
Posted: Wed Jun 04, 2014 7:51 am
by handofdave
martin at chiselspeed will machine one to the profile of your make of piston and correct cr
Re: 200 cylinder head
Posted: Wed Jun 04, 2014 7:19 pm
by YAMLAM
handofdave wrote:martin at chiselspeed will machine one to the profile of your make of piston and correct cr
what is Correct cr these days ?
AF list 3 200cc Heads, 8:1 , New Type 9.5:1 and STD (what ever that is ).
Re: 200 cylinder head
Posted: Thu Jun 05, 2014 5:33 pm
by sjc
thats wot im trying to ask yamlam...........
Re: 200 cylinder head
Posted: Thu Jun 05, 2014 6:33 pm
by handofdave
i always use 9.5:1