Page 1 of 1
Anyone know?
Posted: Fri May 16, 2014 4:12 pm
by junkyard
Dose anyone have Lee Rocho contact details please as I need a complete set of steels and top plate for one of his clutches.
Cheers in advance,
Junkyard.
Re: Anyone know?
Posted: Tue Jun 10, 2014 5:27 am
by nicsar
Any luck on this one?
Re: Anyone know?
Posted: Tue Jun 10, 2014 10:30 am
by Smurf SX
PM sent Junkyard
Re: Anyone know?
Posted: Thu Jun 11, 2015 1:24 pm
by nicsar
One year since my last post and Im still looking for new steels for my rocho clutch..
Can someone tell me from what bike they are ,or point me to Rocho so I can get the info from him.
I just bought a complete set with, plates, springs and steels for a RS 125. The plates and springs seem to be correct but the steels dont fit.
Thanks,
-n
Re: Anyone know?
Posted: Thu Jun 11, 2015 9:51 pm
by wack 63
After having no luck with Lee and the steels cupping, I used some 1.2mm Lamby ones and turned them down to fit. The top plate is also turned down in diameter.
Re: Anyone know?
Posted: Fri Jun 12, 2015 5:17 am
by nicsar
Thank you mr wack.
I´ll get a set of Lambretta steels then.
Was yours a 5 plate clutch?
Re: Anyone know?
Posted: Fri Jun 12, 2015 6:40 am
by wack 63
6 plate