piston ring peg

[Tosh]

just rebuilding a mates scooter gp200 engine and noticed that the top ring pin is no were near out as far as the bottom ring pin.
what options do I have ? new hole put in,Or a new pin put in, Its just a std indian top end.

Ta Paul

[tavspeed]

might be the the top one is good,and the bottom is coming loose,is it the original piston or a new one.

[Eibar]

Get yourself to "Grampian Engineering" to get it re pinned (not too far away from you)

[Eibar]

just re read your post and noticed its an indian top end so I assume its a cheapo piston and re pin may outweigh just buying a replacement unit

[Tosh]

thanks for the replys,as for assuming a cheap piston which is prob correct but I`ve had the same troubles with a peg coming out of an asso piston and messing up my top end up after it had been sorted to 14.65bhp..

and also it is the original piston