HELP...Asso 67mm + 2 ring pistons

[a.j]

WHERE THE HELL ARE THEY? Has anyone got a clue to where I can buy one?

[Timbo]

I had a rebore recently and struggled to find a piston I think between 66 and 67. Went for a 68 Racetour...

[camel]

i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

[a.j]

i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

Thats what I got in the end, but it was a 67.5 & Chiselspeed charged me £53.. THEN i found out Scooteresto's are doing them for £35.

I heard the SR piston has the hole too deep for the ring pegs causing the rings to spin...any evidence of this?

[camel]

i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

Thats what I got in the end, but it was a 67.5 & Chiselspeed charged me £53.. THEN i found out Scooteresto's are doing them for £35.

I heard the SR piston has the hole too deep for the ring pegs causing the rings to spin...any evidence of this?

i personally cant comment on that fact,ive just built a reed iron barrel with one in so hope not

[a.j]

i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

Thats what I got in the end, but it was a 67.5 & Chiselspeed charged me £53.. THEN i found out Scooteresto's are doing them for £35.

I heard the SR piston has the hole too deep for the ring pegs causing the rings to spin...any evidence of this?

i personally cant comment on that fact,ive just built a reed iron barrel with one in so hope not

Exactly what I'm having done...

[goldeneye]

beedspeed have some 2 ring 67mm "race" pistons with chrome rings, last oversize on the 200 version.

[steviegp200]

WHERE THE HELL ARE THEY? Has anyone got a clue to where I can buy one?

think rayspeed have them but im sure they have 3mm trimmed off the inlet side of skirt

[a.j]

No, out of stock mate.

[steviegp200]

got one wi the rings melted into it if yir lookin for a paper wieght happy hunting mate