Scooterotica

WHERE THE HELL ARE THEY? Has anyone got a clue to where I can buy one?

I had a rebore recently and struggled to find a piston I think between 66 and 67. Went for a 68 Racetour...

i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

camel wrote:i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

Thats what I got in the end, but it was a 67.5 & Chiselspeed charged me £53.. THEN i found out Scooteresto's are doing them for £35.

I heard the SR piston has the hole too deep for the ring pegs causing the rings to spin...any evidence of this?

a.j wrote:

camel wrote:i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

Thats what I got in the end, but it was a 67.5 & Chiselspeed charged me £53.. THEN i found out Scooteresto's are doing them for £35.

I heard the SR piston has the hole too deep for the ring pegs causing the rings to spin...any evidence of this?

i personally cant comment on that fact,ive just built a reed iron barrel with one in so hope not

camel wrote:

a.j wrote:

camel wrote:i like the sr 200 pistons.....up to 67mm and thin wire rings...35quid.

Thats what I got in the end, but it was a 67.5 & Chiselspeed charged me £53.. THEN i found out Scooteresto's are doing them for £35.

I heard the SR piston has the hole too deep for the ring pegs causing the rings to spin...any evidence of this?

i personally cant comment on that fact,ive just built a reed iron barrel with one in so hope not

Exactly what I'm having done...

beedspeed have some 2 ring 67mm "race" pistons with chrome rings, last oversize on the 200 version.

a.j wrote:WHERE THE HELL ARE THEY? Has anyone got a clue to where I can buy one?

think rayspeed have them but im sure they have 3mm trimmed off the inlet side of skirt

No, out of stock mate.

got one wi the rings melted into it if yir lookin for a paper wieght happy hunting mate