Page 1 of 1
lambretta 150 casings ,machined to 200
Posted: Tue Nov 26, 2013 10:51 pm
by tarmac templar
cant remember the name of the firm in Barnsley who does this ...anybody used them or know the name cheers
Re: lambretta 150 casings ,machined to 200
Posted: Fri Nov 29, 2013 4:40 pm
by satans reject
ive just had my 150 casings welded and machined to 200 spec by c.s enginerring in Norwich tel-01603 414666.
hope this helps, even though its not in yorkshire but remember, nowt good ever come's from the wrong side of the pennines.........
Re: lambretta 150 casings ,machined to 200
Posted: Fri Nov 29, 2013 5:15 pm
by gaz_powell
OilTek in Barnsley
I`ve got one been done as we speak
wide mouth SIL 125 £125 cash
Re: lambretta 150 casings ,machined to 200
Posted: Sat Feb 01, 2014 4:29 pm
by gaz_powell
Got mine back from Paul at Oiltek
great job and a nice bloke
would recommend them
gaz
Re: lambretta 150 casings ,machined to 200
Posted: Sat Feb 01, 2014 4:41 pm
by mick1
Do they take 2 months to do ?
Re: lambretta 150 casings ,machined to 200
Posted: Sat Feb 01, 2014 8:01 pm
by Lamaddict
I'd also recommend CS Engineering. He rework my Li125 casing to an RB 250 size. He also vapor blasted the casing.
Re: lambretta 150 casings ,machined to 200
Posted: Sat Feb 01, 2014 9:18 pm
by soulsurfer
Are all these conversions nicely finished off on the outside? The best job of this conversion I've seen is by MB, finished off so nicely that you could hardly tell it'd been converted, some are just welded up and bored out leaving a right mess on the outside, okay if you're no fussy I guess...
Re: lambretta 150 casings ,machined to 200
Posted: Sat Feb 01, 2014 9:29 pm
by Lamaddict
Mine looked very neat and a lot cheaper than MB. I posted a pic of it on here somewhere.
Re: lambretta 150 casings ,machined to 200
Posted: Sat Feb 01, 2014 9:40 pm
by newmanlammy
oil tech machine round the weld where possible, there's a video of the cnc machining it on utube