Page 1 of 1
Jet 200 Floor Mats
Posted: Wed Oct 30, 2013 7:56 pm
by Doom Patrol
What would people recommend for gluing the floor mats on a Jet 200? I'm thinking something silicony perhaps, that you can mix up and spread evenly on the back. I'd be interested in peoples experience of this.
Re: Jet 200 Floor Mats
Posted: Wed Oct 30, 2013 8:19 pm
by storkfoot
I used bathroom silicon on my Lynx. It was fine. They never moved and it would be easy to remove if needed.
Re: Jet 200 Floor Mats
Posted: Wed Oct 30, 2013 8:55 pm
by Doom Patrol
I must admit it's something I've never done and don't know a lot about it. I always think of silicone being in tubes and used with a gun. How did you apply it?
Re: Jet 200 Floor Mats
Posted: Wed Oct 30, 2013 10:51 pm
by carlos fandango
Contact adhesive
thats how they were stuck down originally
If you want to remove the old glue, soak in cellulose thinners
Re: Jet 200 Floor Mats
Posted: Wed Oct 30, 2013 11:50 pm
by maskie66
some silcone may not be paint or metal friendly it would be contact adhesive for me nev..
Re: Jet 200 Floor Mats
Posted: Thu Oct 31, 2013 9:56 am
by DigDug
maskie66 wrote:some silcone may not be paint or metal friendly it would be contact adhesive for me nev..
Silicone - it's inert isn't it?
Re: Jet 200 Floor Mats
Posted: Thu Oct 31, 2013 9:57 am
by DigDug
storkfoot wrote:I used bathroom silicon on my Lynx. It was fine. They never moved and it would be easy to remove if needed.
I can vouch for that....
