Page 1 of 1
Flywheel, long fin to short
Posted: Fri Oct 04, 2013 8:30 am
by Minority
Does anyone know exactly how much has to be machined off a standard SIL long fin flywheel to make it the same height as the standard flywheel (and therefore be able to fit a standard cowling).
Cheers, John
Re: Flywheel, long fin to short
Posted: Fri Oct 04, 2013 9:18 am
by bristolmod
a standard flywheel is 62.5mm from front of fin to back of rotor. Measure your long fin in the same way and "do the math"
Chris
Re: Flywheel, long fin to short
Posted: Fri Oct 04, 2013 11:43 am
by Minority
Thanks Chris, I should be able to manage that
Re: Flywheel, long fin to short
Posted: Sat Oct 05, 2013 5:50 am
by Minority
For anyone else thinking of doing this, my SIL long fin flywheel measured 69mm. This means machining off 6.5mm to come to Chris's 62.5mm standard flywheel.
(See, I did manage the math Chris
)