Page 1 of 4
Serveta 200 with a snapped crank, ooops :-(
Posted: Sun Sep 22, 2013 6:49 pm
by lambro
Mates scooter on the way back from Woolacombe today,
Good plug colour and running well, then
BANG 
Conrod let go, and chopped his matching numbers case in half, less than 25mm of alloy left holding the 2 sections together
Anyone else seen this happen
Shaun.
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 7:26 pm
by lockman69
Nasty
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 7:59 pm
by goldeneye
happened to chinky Phil on his GP a few years back, peppered everyone behind with shrapnel.
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 8:04 pm
by Morgan
Casings for sale, already opened for rotary induction, may require some welding...........
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 8:06 pm
by yam-lam
was it a recently new engine build
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 8:30 pm
by wack 63
Has the casing been pushed apart to explain the gap between the web and driveside plate?
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 11:18 pm
by Elite-225
Wow .. that be scary lookin s**t! .. I used to think mec cranks were ok, i have heard some stories about them recently but that is just too much evidence .. ( i still blame the Fuel) .. its a conspiracy !!
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 11:20 pm
by Muttley McLadd
The piston doesn't look too bad.
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 11:22 pm
by Muppet
Schwalbs
Re: Serveta 200 with a Mec crank, ooops :-(
Posted: Sun Sep 22, 2013 11:23 pm
by Muttley McLadd
Wrong polish?
