Page 1 of 2
Vespa p range crank con rod conversion
Posted: Fri Aug 16, 2013 6:56 pm
by ruevespamad
Hi people,i am planning a top end conversion on a px 125 bottem end.By my preliminary measurements i will need a con rod of 125 mm in length..anyone know what rod to use-preferably with a 16 mm gudgeon pin? And any recomendations on who to use to build the crank for me? Thanks,Rich.
Re: Vespa p range crank con rod conversion
Posted: Fri Aug 16, 2013 7:49 pm
by ducksta
depends where you live m8 yorkshires full of experts
Re: Vespa p range crank con rod conversion
Posted: Fri Aug 16, 2013 8:07 pm
by ruevespamad
Tamworth Staffs mate but dont mind travelling or post etc to use the best...
Re: Vespa p range crank con rod conversion
Posted: Fri Aug 16, 2013 8:08 pm
by ruevespamad
Tamworth Staffs mate but dont mind travelling or post etc to use the best...
Re: Vespa p range crank con rod conversion
Posted: Fri Aug 16, 2013 8:10 pm
by ruevespamad
bloody laptop bein an ass!
Re: Vespa p range crank con rod conversion
Posted: Sat Aug 17, 2013 7:32 am
by LI150
Chiselspeed in Leeds are ment to be good
Re: Vespa p range crank con rod conversion
Posted: Sat Aug 17, 2013 9:58 am
by gaz_powell
Agree Chisel in Leeds or Harry Barlow in Leicester
Re: Vespa p range crank con rod conversion
Posted: Sun Aug 18, 2013 9:16 am
by ducksta
used both very very good
Re: Vespa p range crank con rod conversion
Posted: Sun Aug 18, 2013 9:23 pm
by ruevespamad
Have actually dealt with Harry,some years ago mind.Found him to be a sound bloke-anyone have a current number for him?
Re: Vespa p range crank con rod conversion
Posted: Tue Aug 20, 2013 7:12 am
by OzOAP
Have you sourced a 125mm rod?