Lambretta hub stud thread size.

Anything related to Lambrettas... ask tech questions, post helpful info, or just read and learn.
Post Reply Previous topicNext topic
Minority
registered user
Posts: 673
Joined: Wed Feb 01, 2012 2:00 pm
Main scooter: Li230 S3
Location: Perth, Western Australia
Contact:
Contact Minority

I have seen this quoted as 11mm x 1 for Italian hubs, but on taking the studs out of genuine SX200 front hub in preparation for fitting SIP Rims, I reckon that they are 10mm x 1.
Anyone have the definative answer?
(I know if the SIP studs fit who cares, but I am having to drill one stud out (there's always one that won't come out :( ). I only have normal right hand thread taps so I want to get a left hand tap incase I have to clean up the thread).
Top
rosscla
registered user
Posts: 4823
Joined: Tue Oct 25, 2011 9:50 pm
Main scooter: Lambretta
Location: Lanarkshire
Contact:
Contact rosscla

I have a m10 x 1 LH tap which I used to clean mine up and the studs fit fine after.
"Our dilemma is that we hate change and love it at the same time; what we really want is for things to remain the same but get better."
Top
Minority
registered user
Posts: 673
Joined: Wed Feb 01, 2012 2:00 pm
Main scooter: Li230 S3
Location: Perth, Western Australia
Contact:
Contact Minority

Thanks for that mate, I managed to drill out the stud without damaging the thread at all so didn't need to get the tap anyway.
Re-measured the studs that came out (the easy ones not the last pig that I had to drill out) and definately 10 x 1.
Top
Post Reply Previous topicNext topic

Return to “Lambretta Tech”

  • Information

  • Who is online

    Users browsing this forum: No registered users and 18 guests

Powered by phpBB™ • Design by PlanetStyles