Page 1 of 1
Where should i be ?
Posted: Wed Aug 07, 2013 9:07 am
by Bifter
I keep seeing lots of numbers floating round about the different hp of a malossi 210 and i was wondering what the least i can expect from a kit ported with a mazzy crank scorpion pipe on a standard carb with ram air ? i know all engines are different but what would you hope to get out of that set up ?
Re: Where should i be ?
Posted: Sat Aug 10, 2013 12:07 pm
by MCH
same as you depending on setup, i have read in numerous places different bhp out puts, but as a rule of thumb iv always read that it will push out 18 bhp minimum no matter what setup
Re: Where should i be ?
Posted: Sat Aug 10, 2013 1:19 pm
by Bifter
Thanks MCH at least i have an idea now ,did have it set up on the dyno on monday but its an old one and don't tell you the bhp as far as i know