Hello,
Do you know if the rear hub nut does exist in different dimension?
Here below my problem
Original Nut from my original LIS engine
Original nut + fixing kit for SIL hub
I can't fix the hub....i have too many space between the hub and the nut
What esle ?
Rear Hub NUT GP on SIL engine
-
- registered user
- Posts: 19
- Joined: Fri Feb 27, 2009 10:13 am
- Location: Liège - BELGIUM
- Contact:
From Jupiler Skouter Club
is the cone shim on?
-
- registered user
- Posts: 19
- Joined: Fri Feb 27, 2009 10:13 am
- Location: Liège - BELGIUM
- Contact:
Cone shim = part nr 20 ?
Yes it 's on...but i'm not sure that's the orginal one...the shim that i use is 1mm thick...
From Jupiler Skouter Club
don´t use grease there.
for the nut, there are nuts with a deeper head. also had that problem on some scooters.
essential also is the cone. there are 3 different types of angles. the angle in the rear hub and the cone you use must be the same. its absolutely essential.
for the nut, there are nuts with a deeper head. also had that problem on some scooters.
essential also is the cone. there are 3 different types of angles. the angle in the rear hub and the cone you use must be the same. its absolutely essential.
-
- registered user
- Posts: 19
- Joined: Fri Feb 27, 2009 10:13 am
- Location: Liège - BELGIUM
- Contact:
Ok thanks for your help..i 'll try with a longer nut
From Jupiler Skouter Club
No 20.vespinello wrote:
Cone shim = part nr 20 ?
Yes it 's on...but i'm not sure that's the orginal one...the shim that i use is 1mm thick...