Page 1 of 1
yamaha 110mm rod
Posted: Sat May 04, 2013 7:11 pm
by camel
ordered a rd 125 rod kit from yambits but it was tiny,think it was for a very early twin 125 i have since been informed
So what is the rod kit im after
125lc?
350lc?
just double checking as i dont want to f@@k up twice
Re: yamaha 110mm rod
Posted: Sat May 04, 2013 7:55 pm
by gaz_powell
RD250 Yambits ref COK005
Re: yamaha 110mm rod
Posted: Sun May 05, 2013 11:44 am
by camel
cheers Gaz
Re: yamaha 110mm rod
Posted: Sun May 05, 2013 3:25 pm
by Muppet
.
Re: yamaha 110mm rod
Posted: Sun May 05, 2013 7:39 pm
by gaz_powell
The rd rod is wider than than a standard bretta so you need to machine the webs to get the get the correct overall width. I'm back home tomorrow and will post the width you are aiming for (can't remember of the top of me head)
Re: yamaha 110mm rod
Posted: Sun May 05, 2013 8:03 pm
by Muppet
.
Re: yamaha 110mm rod
Posted: Fri May 10, 2013 8:09 pm
by corrado
RD125YPVS is 110mm, Grampian fitted one to SIL crank for me but they used a better big end bearing possibly RD500 from memory.
Straight RD125 uses 98mm rod.