Page 1 of 1
LAMBRETTA GP HEAD LIGHT JUNCTION BOX / BULB HOLDER.
Posted: Thu Mar 28, 2013 11:25 am
by Tosh
whats the best type sick of wires coming out on these crap roads we have to ride on
some people have used electrical blocks instead to connect all there wires and then wires from their to the bulb holder
Re: LAMBRETTA GP HEAD LIGHT JUNCTION BOX / BULB HOLDER.
Posted: Thu Mar 28, 2013 1:57 pm
by Minority
Re: LAMBRETTA GP HEAD LIGHT JUNCTION BOX / BULB HOLDER.
Posted: Thu Mar 28, 2013 9:48 pm
by Tosh
Ta minority for that will take a close look at them
Re: LAMBRETTA GP HEAD LIGHT JUNCTION BOX / BULB HOLDER.
Posted: Thu Mar 28, 2013 10:12 pm
by Andy Pickering
I've had a scooter restorations one in for 5 years and still good to go
Sent from my GT-I9300 using Tapatalk 2
Re: LAMBRETTA GP HEAD LIGHT JUNCTION BOX / BULB HOLDER.
Posted: Fri Mar 29, 2013 5:59 pm
by mac
I've had a few from Scooter Restorations and they've been the best I've found and not had any probs with them.
Re: LAMBRETTA GP HEAD LIGHT JUNCTION BOX / BULB HOLDER.
Posted: Sat Mar 30, 2013 1:25 pm
by corrado
I start by closing the female receptors in the wiring block a bit using some thin nose pliers.
I was thinking of soldering some short lengths of cable into the block with the correct colour wire for each connection, then converting all the connections to blade type with waterproof covers.