Page 1 of 1
ts1 gearing
Posted: Sat May 02, 2009 12:05 am
by dodobeckam
running standard ts225,devtour pipe,tmx 35,li 150 box...wich sprocket arangement would suit this please.........thanks mike
Re: ts1 gearing
Posted: Sat May 02, 2009 12:24 am
by sean brady scooters
a lot depends on how overweight your are matey..........and also if you expect also to ride two,s up with your overweight missis.............
only joking mate...........
what are you running now..........?
and why do you think it wants or needs correcting/improving........?
Re: ts1 gearing
Posted: Sat May 02, 2009 7:22 am
by soulsurfer
16/47 on mine which at 4.9 is supposed to be perfect for the pipe. Well I love it anyway at a little over 12 stone
Re: ts1 gearing
Posted: Sat May 02, 2009 7:26 am
by mark
16/46 on mine and im only just 15 stone
Re: ts1 gearing
Posted: Sat May 02, 2009 6:05 pm
by camel
im on 16x46 with an li box and on a series 2 with a dev tour..should pull your bike
Re: ts1 gearing
Posted: Sat May 02, 2009 8:04 pm
by hydra
I really have same question, TS1 but with JL3, tmx 35, Li 150 box. Was told by a few in the Know to use 18/47, but spoke to guy who had this in and told he was never out of 3rd gear, so he fitted 16/47, perhaps 17/47 would have been better, though stretched 81 link chains must be like Hens teeth. Anyway I'm thinking of reverting back to the 46 Crownwheel and 17 front sprocket, reasoning behind this is I have 225 Muggelo with 46/16 and it runs with ease so TS should be ok with 17 front sprocket. I think ratio is 4.6 .By the way the guy with 16/47 loves it.
Re: ts1 gearing
Posted: Sat May 02, 2009 8:12 pm
by noggin1969
TS1 with JL3, tmx 35, Li 150 box 16 x 46 pulling my lardy 17 stone ok
Re: ts1 gearing
Posted: Sat May 02, 2009 8:12 pm
by davidblythe
I run LI 150 17 46 81 Link chain which is 4.6 on a taffy tmX35 V force 125 tfr TS1, runs fine up hill and down dale peaks at 7200 rpm 80mph
Re: ts1 gearing
Posted: Sun May 03, 2009 5:53 pm
by Stampede
hydra wrote:I really have same question, TS1 but with JL3, tmx 35, Li 150 box. Was told by a few in the Know to use 18/47, but spoke to guy who had this in and told he was never out of 3rd gear, so he fitted 16/47, perhaps 17/47 would have been better, though stretched 81 link chains must be like Hens teeth. Anyway I'm thinking of reverting back to the 46 Crownwheel and 17 front sprocket, reasoning behind this is I have 225 Muggelo with 46/16 and it runs with ease so TS should be ok with 17 front sprocket. I think ratio is 4.6 .By the way the guy with 16/47 loves it.
got the 18/47 in my engine with a li150 gearbox - it pulls the ratio easily, but my engine got about 35NM torque at this time....