Scooterotica

I'm fitting an RD piston into a reed valved SR185 barrel and I'm after a wide small end bearing.

I got one off ebay for an RD, but now I have offered it up to the small end eye, the bearing is too big (OD). There was me thinking they were all the same.

Which small end should I be looking for?

Martin

i,m pretty sure it was the TZ type bearing

Thanks guys.

By chance, I found the leaflet that came with my original purchase. I think I'll give them a call to make sure I order the correct one bnext time. They promise a large selection of older pistons and rods. They might turn out to be a useful contact.

Martin