Scooterotica

Could anyone please advise the various setups possible when replacing the std monza reed block/inlet, the std one has the recessed block but assume you can use an aftermarket reed block if you change the inlet (LTH or similiar)
Any advice appreciated.

are you looking to replace because yours is broke? or want better panel clearance or performance improvement?

Hi, it is a performance upgrade

You can change the manifold but you'll need to do some measuring of reeds because I believe the std Monza reed is narrower so using an RD etc reed may need some work.

thats right the reed box needs porting out to accept the larger reed assembly