Page 1 of 2
Cable ties
Posted: Fri Mar 01, 2013 9:06 pm
by Jxmiddle
Plastic ties or aluminium? Other than the obvious - cheap plastic vs original nice looking ally - any preferences?
Re: Cable ties
Posted: Fri Mar 01, 2013 9:37 pm
by squeakmillward
depends if your doing a concourse resto or an ordinary get it on the road jobby
you really wont see them with all the panels on but if an anorak were to buy your scooter the pet lip may come out if described as original lol!
Re: Cable ties
Posted: Fri Mar 01, 2013 9:53 pm
by Elite-225
Not bothered bout resto stuff .. but the Ali ones can be easier to release for cable replacement etc.
Re: Cable ties
Posted: Fri Mar 01, 2013 11:15 pm
by Timbo
Plastic for me, easy to fit..
Re: Cable ties
Posted: Sat Mar 02, 2013 1:06 am
by Jxmiddle
Good point Squeakmillward, preservation of value leans towards ally though something about pleasing potential anorak buyers just makes me want to go all plastic......
Re: Cable ties
Posted: Sat Mar 02, 2013 8:21 am
by thebassmasta
plastic for me. easier, cheaper, b******s to the anoraks
Re: Cable ties
Posted: Sat Mar 02, 2013 12:17 pm
by Doom Patrol
Both!
Re: Cable ties
Posted: Sat Mar 02, 2013 1:27 pm
by corrado
thebassmasta wrote:plastic for me. easier, cheaper, b******s to the anoraks
Electricians tape it is then.
Re: Cable ties
Posted: Sat Mar 02, 2013 7:32 pm
by 10 inch Terror
Plastic all the way for me. I also use them to hold the panel buffers on instead of the akward metal clips.
Re: Cable ties
Posted: Sat Mar 02, 2013 8:25 pm
by Doom Patrol
10 inch Terror wrote:Plastic all the way for me. I also use them to hold the panel buffers on instead of the akward metal clips.
Burn him!