Page 1 of 1
Fork nut C spanner
Posted: Wed Jan 02, 2013 1:06 pm
by Blistered Baz
Just a quickie...
Need to put a new front mudguard on me Vespa this weekend and was wondering what the chances are of the c spanner required being the same size as the Lammy one I already have?? Any ideas?
Re: Fork nut C spanner
Posted: Wed Jan 02, 2013 1:45 pm
by GLscoot
I couldn't tell you. There is a better tool out now, you will find it on eBay. If you don't want to spend £20, then a large flat screw driver and a plastic head hammer will do the same job.
Gary
Re: Fork nut C spanner
Posted: Wed Jan 02, 2013 2:25 pm
by Blistered Baz
Cheers Gary, I was hoping to avoid the hammer / screwdriver method if at all poss, but it's a relatively new PX (2003) so shouldn't be seized if i do have to resort to plan B...
Re: Fork nut C spanner
Posted: Tue Jan 08, 2013 11:39 pm
by Scooterso
Blistered Baz wrote:Just a quickie...
Need to put a new front mudguard on me Vespa this weekend and was wondering what the chances are of the c spanner required being the same size as the Lammy one I already have?? Any ideas?
they are the same size. i use my Piaggio factory tool for the top nut with 4 slots on Lammys all the time.
Re: Fork nut C spanner
Posted: Wed Jan 09, 2013 11:10 am
by Blistered Baz
Yeah I did it at the weekend, must admit I was surprised that it was the same size!! Saves buying another tool anyway, bonus
