Page 1 of 1
pro design bullet
Posted: Mon Dec 24, 2012 7:55 pm
by sonicdave
Has anyone got any experience with this pipe.
I'm looking for an RB style pipe that I can modify to fit on my kdx barreled engine.
Re: pro design bullet
Posted: Mon Dec 24, 2012 8:02 pm
by WINTERMODEL150
Why not use a kdx pipe and then modified it to fit your frame?just a thought
Dean
Re: pro design bullet
Posted: Mon Dec 24, 2012 8:08 pm
by sonicdave
Already done that and kx250 pipe.I'm not that good a welder and have never been that happy with my pipes.Just looking to put on a performance pipe with proven abilities with minor modifications.
A custom pipe is out of the question as I'm in the USA
Re: pro design bullet
Posted: Tue Dec 25, 2012 3:39 am
by Grumpy225
I have one on my rb20. Very well made and a good fit. Nice kick around 6k and kept on going to 9ish.
The only thing I didn't like about it was there was no end can support so the can bumped the kick lever bolt. It's an easy enough fix I just haven't had the time to mess with it.
Re: pro design bullet
Posted: Sun Dec 30, 2012 1:47 am
by sonicdave
Thanks Mike.Your cutdown looks like my sx200 cutdown from the mid 80's.
A cutdown is in my future again,have most of the parts,but not enough time for all my projects.
Re: pro design bullet
Posted: Sun Dec 30, 2012 1:58 am
by dirtyhandslopez
Dave, there has to be someone close by to you who can weld a pipe up. Have you tried and bike/motorcross shops? Y'know, land of opportunity an' all that.
The trouble with a scooter shop offering that servce is that they are going to have to be close so's you can send the frame and motor. Barry isn't set up for getting tiggy yet?