Page 1 of 1
cylinder head cowling...
Posted: Wed Nov 28, 2012 5:36 pm
by clockwork
Ive just been taking a few bits of my GP ie my shinny engine bits for a good clean....I have a problem with removing the cylinder head cowling..there doesnt seem to be enough clearence between the cowling and the frame to remove the cowling.. i was just wondering if there is a trick to getting it out? ....when you stop laughing would be great of the info
Re: cylinder head cowling...
Posted: Wed Nov 28, 2012 5:51 pm
by clockwork
Eden wrote:Take rear shock off and remove bump stop rubber. It will then tilt enough to get it off.
sent from my phone via tapatalk
Thanks for speedy reply i will give it a go....
Re: cylinder head cowling...
Posted: Wed Nov 28, 2012 11:51 pm
by corrado
For everything else there's Mastercard.
Re: cylinder head cowling...
Posted: Thu Nov 29, 2012 3:02 pm
by clockwork
corrado wrote:
For everything else there's Mastercard.
cheers mate got a dog eared copy here,,,,havnt got a mastercard though :bigsm:
Re: cylinder head cowling...
Posted: Thu Nov 29, 2012 3:15 pm
by rosscla
clockwork wrote:,,havnt got a mastercard though :bigsm:
Got about six...you can have one for free but you've got to take the balance on with it...
Re: cylinder head cowling...
Posted: Thu Nov 29, 2012 5:44 pm
by clockwork
rosscla wrote:clockwork wrote:,,havnt got a mastercard though :bigsm:
Got about six...you can have one for free but you've got to take the balance on with it...
:biggrin: Hahaha nice one thought you were gonna say if youve got a stickys why the f..k dont you use it lol.