Lambretta Workbench

[Spud]

Anyone recommend a supplier of these, preferably in the West Midlands?
Just rang the fella who is advertising them in JetSet, but he has stopped doing them
Seen a few on ebay, but not sure of the quality!

cheers
Spud

[jazzyb]

got this from martins at retford £275 about two month ago fetched itmyself

[Spud]

what width is that one?

[lcs99]

Spud, got a Sealey one years ago, I had to widen the sides to get my series 1 and 2 on it. When you jack it up, the Sealey one as got a ramp at the rear that is angled down so my lambretta is never straight. (hope that makes sense) The one that jazzyb as got is a better one by far.

[jazzyb]

hi spud 220 cm -68cm it is longer and wider than the one in jet set they are on ebay or martins galore website hope this helps i was not happy about the bits of plate that stick out for the feet on the smaller ones but thats just my opinion

[Spud]

Is this the same one?

cheers for the advice

[jazzyb]

That's the place but he does 2 sizes if u read the discription I av the bigger one hope this helps