Scooterotica

hi does anyone know or have fitted pm tuning pro street levers to a series 2
phoned pm tuning and they didnt know if they would fit
cheers steve

they wont .. you would need late indian clutch and throttle lever supports

RICSPEED wrote:they wont .. you would need late indian clutch and throttle lever supports

hi thanks do you mean i would have to fit a indian gp type gear change support, i dont need the throttle side as got hydraulic fitted
cheers steve

indian gp -
http://www.ebay.co.uk/itm/LAMBRETTA-GP- ... 3f16641e6a

series 2 -
http://www.ebay.co.uk/itm/LAMBRETTA-LI- ... 5ae99b57de

ok compare the two ...you will see that the series 2 type (second link )is straight where the lever meets the housing where as the gp type is not ..fit the late indian type then you can fit the pm levers as i belive they do one for the nissin type m/c

^^^ They're not a straight fit tho' as the handlebars are thicker on a S2 so these would need the inside opening up to slide over the handlebar.

Hi
You can fit them but you have done a little griding on them

soulsurfer wrote:^^^ They're not a straight fit tho' as the handlebars are thicker on a S2 so these would need the inside opening up to slide over the handlebar.

Yes you are correct .. I had forgot about that ... Then as above you need to cut to suit

Jason Frost suggests the Vespa ones should fit, is that right, the vespa lever is the same fit as a S2?

Vespa levers do fit but you still have to some grinding.

hi i bought some of the scootrs atomic levers for the px vespa and they have fitted the series 2, no problems whatsoever
cheers steve