Scooterotica

i converted my series 1 to have a brake light using an original 3 bulb rubber mounted set up but noticed its melting the bottom of my lense where the clear section meets the red. Does anyone male led conversions for this type of rear light?

I got a BGM one from scooter centre - It works really good and is nice and bright

This eBay seller does led boards, I have one in my GP

item number

HID light sellers usually have sm led "bulbs" with conventional fittings, if that's what you mean.
http://www.autobulbsdirect.co.uk/LED-Car-Bulbs-c-1337/

I've just got these to fit in the rear lens, look the same as the pre made one on ebay,nice and flexible and covered in silicon so waterproof.http://www.ebay.co.uk/itm/200589590655? ... 1423.l2649

Yeah, I bought a pair of these too and have spent most of yesterday doing it, one set for brakes the other set for running, all wired up just like the old bulb but they both come on on brakes and the wires so thin as to be ridiculous to work with

Think I might just have to invest in a proper one from MB

Put mine around oringal bulb 1 for brake and 1 for running, it means if the led or the bulb fails I will still have lights.

AHA, I seem to have had a eureka moment after yesterdays alzheimers moment!

I seem to have sussed it, stupid Donnie had it in his head that 3 wires (1 pink, 2 black) was 1 power 2 earth, doh!!

Course there's only one common earth as pinks power from the brake switch and the other blacks the running light, silly sod I am.

Now, where'd I put all them bleeding zip ties.??