Forever Tinkering
Posted: Wed Aug 29, 2012 10:35 am
Been tinkering round yet again 
Had a spare 200 barrel setup and wondered what would happen if a feed was added from the exhaust outlet via drilled holes aligned in the piston skirt ~ Started off with 2 x 2.50mm holes and have now stopped @ 2 x 3.50mm ~ Don"t want to go any bigger as there is strong possibility it will begin to be a pig starting
Can"t say there has been any power increase @ all ~ But egt readings definitely lower @ speed
Anybody else done or know of any information on this " tinkering " ?
Had a spare 200 barrel setup and wondered what would happen if a feed was added from the exhaust outlet via drilled holes aligned in the piston skirt ~ Started off with 2 x 2.50mm holes and have now stopped @ 2 x 3.50mm ~ Don"t want to go any bigger as there is strong possibility it will begin to be a pig starting
Can"t say there has been any power increase @ all ~ But egt readings definitely lower @ speed
Anybody else done or know of any information on this " tinkering " ?
..good to see you at York