Malossi 211 with PM Up'n Over -need help
Posted: Wed Aug 22, 2012 7:41 am
Gents,
Just built me a proper ratbike with a Malossi 210 reed engine. Modified Malle210, Worb5 crank, Malossi reed and a PHBH 30. And a PM Up'n Over...
Any advis of seting the carb for this?
I have;
Idle: 55
Needle: X2 on top clip
Main jet 135.
It goes well on low rpms, but higher up it splutters.
-thought it was flywheel side seal, but that's perfect.
Any tips on the carb?
Ø
Just built me a proper ratbike with a Malossi 210 reed engine. Modified Malle210, Worb5 crank, Malossi reed and a PHBH 30. And a PM Up'n Over...
Any advis of seting the carb for this?
I have;
Idle: 55
Needle: X2 on top clip
Main jet 135.
It goes well on low rpms, but higher up it splutters.
-thought it was flywheel side seal, but that's perfect.
Any tips on the carb?
Ø