Exhaust question.

[Fux]

I`ve got a Mk.1 GS with a SS180 engine.

The engine has had a full overhual and been converted to 12v leccy. It goes realy well but these repro pipes are a bag of poo.

Am I correct in thinking that if a fit one of these http://www.sip-scootershop.com/en/produ ... d_13014380, I can use any p200 pipe?

If so, which pipe would you fellas reccomend? Prefrably torque over revs.

Cheers,
Rob

[cit205]

If you want something subtle but which works well especially for torque i would say one of sip's semi expansions

http://www.sip-scootershop.com/en/produ ... r_24165000

You will still have to do some modifications to the swing arm bracket part of any p-range exhaust to fit it to your SS engine though, even with that stub it won't be going straight on ,says as much in the write up in your link.

[Fux]

Ok cheers.

I have a 120 main jet, any idea as to how high I will need to go on that?

[cit205]

Jetting's trial and error obviously ,but as a guide i only needed to go up one on my rally 200 when i fitted one so it runs a 120 now , you have a different engine and carb but going on that you'd probably need a 122 at a guess .

[Fux]

Cheers. I`ll go up a few and work my way down to a couple.

[Svint1]

Hi Rob,

There are exhaust-conversion kits available for the SS/GS engines.
Just change the exhaust stub on the cylinder, and any PX200 pipe will fit.

Would highly recomend the SIP Road exhaust...

Ø