Page 1 of 1
half circlip for delly 30
Posted: Mon Jul 30, 2012 11:05 am
by DaveTomo
Anyone know where I can get a delly 30 circlip that give a half position on the needle,for example X7 clip position two and half.So that it holds the needle in between the grooves on the needle.A link would be very much appreciated,thank you.
Re: half circlip for delly 30
Posted: Mon Jul 30, 2012 11:17 am
by Toddy
Re: half circlip for delly 30
Posted: Mon Jul 30, 2012 11:27 am
by DaveTomo
Cheers Toddy,had a look on there but not sure which is the one I'm after ,whether its this one
http://www.dellorto.co.uk/merchandise/p ... ctionID=24 or this (which I think is the standard one)
http://www.dellorto.co.uk/merchandise/p ... ctionID=24 so I was hoping an adult could show me which one
Re: half circlip for delly 30
Posted: Mon Jul 30, 2012 11:41 am
by nelson pk
Its neither!
The half clip effect is done by using a small washer under the c clip (I think you'll find that it's not a standard delly part). Cambridge lambretta sell them. Look in the carb jets/needles section.
Re: half circlip for delly 30
Posted: Mon Jul 30, 2012 11:42 am
by Eibar
just take your slide and needle to a supplier of fasteners and get a bag of extremely small washers, make sure they fit over your needle and in the recess on the slide, they cost a few pence so buy loads
Re: half circlip for delly 30
Posted: Mon Jul 30, 2012 11:47 am
by DaveTomo
Thank you chaps,much appreciated found it
http://lambretta.co.uk/catalog/product_ ... ts_id=2866 and thank you for putting me on the right track