Scooterotica

I ordered a flywheel bearing for my DL150 ,when it arrived I fitted the bearing track to my original crank.
Now I realize that the bearing was a NU2205 not a NU205 (that is normally fitted to the DL150).
Question is can I use the NU 2205 bearing on the 150 crank? Maybe if I leave out the spacer in the mag housing?
Any help much appreciated,cheers Nick

bearing fits in mag without the spacer; track fits on the crank but is 4mm longer than the one it replaces; your crank has a 14mm shoulder the 200 crank has a 10mm shoulder; does it fit the answer is yes and no,

muppet,

thanks for your answer Muppet, so what your saying is the bearing parts will fit individually (on crank/in mag housing) but when fitted in the engine the bearing won't run centrally on the track?