Scooterotica

I think I know the answer........ but

I was stripping an old Li150 lump at the weekend and found this damage to the outer "o" seal seating. What do you reckon, replace it or risk it?



Cheers,

Nigel

if just a chip i would use but it looks cracked aswell so i would say bin it and get a indian replacement
saves loads of hassle in future for little outlay

For what they cost nigel id bin it and start again..

got loads in my garage going spare if you are near norwich

Thanks for the replies guys!

And thanks to you Mark for the kind offer, but I'm down in deepest Dorset

So it's off to the scrap bin with it

Cheers

Nigel

Weigh it in, there's got to be 25p's worth of ally there

dirtyhandslopez wrote:Weigh it in, there's got to be 25p's worth of ally there

That much!? I only got £40 for my old Calibra the other week

where abouts in Darrset bud, cos I got a spare one in my garage in Ferndown

mickyb wrote:where abouts in Darrset bud, cos I got a spare one in my garage in Ferndown

Weymouth, Micky. Thanks for your offer, but a mate on Portland has come to the rescue

Cheers,

Nigel :bouncing: