Scooterotica

Hi,

I have a Nk road exhaust with a standard stub... And I've been a twonk and while working on the scooter I've managed to loose part of the chancase bracket.

The bit I've lost is the bit that joins the end can to the chaincase bracket, with the slots cut into it so you can alter the angle. I would really appreciate it if some one with one of these exhausts could send me the dimensions so I can have one made up, or if any one has a spare that thy would be willing to part with.

Cheers,

Is it the flat piece with a hole and a slot ? I'll measure mine tonight for you and let you know.
Russ

You'd probably be better to phone AF and ask if they can sell you one. Steve who makes the pipes will have made loads so it shouldn't be impossible to source a spare.

I have contacted them and they wanted 40 quid for it I think this was for the whole chaincase bracket, but I wasn't sure....

so I was going to get a friend to knock one up...

And yes it is the flat piece, russ. Thanks

Fair enough!

I Decided to go home for lunch so here you are, i forgot to write on, its 5mm thick

Russ

carlos fandango wrote:I Decided to go home for lunch so here you are, i forgot to write on, its 5mm thick

Russ

Well done Russ saved me a job when i got home

Thanks, I've given the measurements to a friend and he will make me one up. Cheers once again.

How good is the nk road on performance, got a monza 240 with jl3 on at moment but fancy a change.

I'm very happy with it my self, though I've not got a whole lot to compare it with. It got good reasults in the scootering review, however I think the franspeed pipe is the flavour of the month