I have found that the wheelbase of 1292mm, so this is a help I can get this set on the jig, but my problem is that Im having to work backwards, ideally I need to know a measurement from ground to the bottom of the side panel, or floor of legshields etc, and how the scooter was when measured, ie on stand, or sat on etc
I have got numerous photos from magazines and got a rough idea from the amount of rear wheel showing etc, but would like to do it a bit more scientificly if possible
I have GP panels, but need to put them in the right places, so I can make the bits that go underneath in the right place, talk about doing things the hard way LOL
some bright spark challenged me to make my own expansion chamber too, damn them, I had to accept of course, so much maths and cone drawing is on the agenda
