Page 1 of 1
pm tuning rear shock
Posted: Fri Jun 08, 2012 8:09 pm
by maskie66
was just looking on pm tuning site and they have a nice billet rear shock which would look ace on my cutdown!!
its quoted as having a 300lb spring !! is this not a little heavy as an r1 shock uses 180/225lb spring ???
will
Re: pm tuning rear shock
Posted: Fri Jun 08, 2012 10:23 pm
by RICSPEED
best ask pm .. could be a typo
Re: pm tuning rear shock
Posted: Fri Jun 08, 2012 11:48 pm
by rosscla
I think the Conversion / replacement springs for the r1 are 225 / 180...I'm sure I read somewhere the original is 400
Re: pm tuning rear shock
Posted: Sat Jun 09, 2012 10:24 am
by maskie66
hi rosscla yeah mate r1 spring rates are 180/225lb and original is 400lb but question was the pm tuning spring rate is quoted as 300lb which im assuming is far to heavy?? have emailed them so will post reply as and when
