Scooterotica

Just got hold of a new Sip Race seat for a Px complete with seat pad and fixing kit.

The seat pad appears to have two bolts attached to it but no bolts?

The seat has no holes so does this mean the seat base has to be drilled for fitting??

The base is going to paint and the pad is goingt o be covered so want to amke sure ive got every thing right.

The seat came with no fitting instructions so has any answers to the above or pictures that may help. Or copy of fitting instructions would be a big help.

many thanks

Phil

http://www.sip-scootershop.com/en/produ ... +_31080000

Check out the download info, there`s a wee fitting guide there

thanks bofs

The sip site talks about drilling????

Gather before paint would be best option??

The bolts attached to the have have screw thread bots coming out from them do they thres into the palstic seat or get bolted

Still confused apogises for being thick

I had one quite a while ago & I think it slid on to two threaded pegs that screwed in to the petrol tank bolt holes at the back & the front was held on with a small locking device& key