Page 1 of 1
px200 mazzerchelli race crank
Posted: Mon Jun 04, 2012 7:50 pm
by H,POOL GADGE
Does anybody know the difference between a px200 mazzerchelli race crank and a px200 standard crank in millimeters the inlet timing
Re: px200 mazzerchelli race crank
Posted: Mon Jun 04, 2012 8:15 pm
by cutitdoon
Standard P2: 160°
P2 Mazzy 60mm: 185°
not sure about the standard (non-60mm) Mazzy tho...
Re: px200 mazzerchelli race crank
Posted: Mon Jun 04, 2012 10:49 pm
by Ivan_200
what about 125/150 crank vs mazzy?
Re: px200 mazzerchelli race crank
Posted: Tue Jun 05, 2012 6:37 pm
by gaz_powell
20mm but that is a straight measurement - it needs to be blended and curved into the 20mm line
give me a shout if you are doing one - i`ve done one before
To be honest i would rather cut/modify/polish a genuine piaggio one than use a mazz
gaz
Re: px200 mazzerchelli race crank
Posted: Wed Jun 06, 2012 1:08 am
by Ivan_200
I already did two stock cranks, cut out 20mm off. Do you have a picture of yours?