Who was it that used a Tillotson carb?

[soosh]

Possibly going down this route on my VS5 project but cant remember who used one on their chop? Drop us a PM and id like to chat further about it.
Cheers

[Craig H]

It was Mark/Pride/Tidd

[soosh]

Cheers

[Adam_Winstone]

Rich Taylor did quite a bit with these whilst developing the GT kit.

[soosh]

Think i remember something about that.Ive been looking into them,quite a few in the range.All i need to do is figure out which one i need.They do a nice one called the "Avenger" its anodised blue but its 30mm.Bit big for what i need but did we really give a s**t about stuff like that years ago? May just but a 2nd hand one off ebay and by a repair kit which may be cheaper.