Scooterotica

Has anyone run a hydraulic hose through the headset clamp/fork bolt hole on a Series 2?

I ran mine down the gap between the clamp and the headset just by the bolt. It then runs over the top of the throttle rod to a hole ground in the bottom headset just below the kinked bit in the headst cover. Sorry not got any photos and cider has impaired my discriptive abilities :fb: :fb:

Yes, just change the headset bolt to a series 3 one.

wrekkah wrote:Yes, just change the headset bolt to a series 3 one.

That's what I was thinking, just wasn't sure as my headset is completely stripped, cheers