Page 1 of 1
thread size on crankshaft
Posted: Wed Mar 14, 2012 1:35 pm
by joespeed
can anyone tell me the thread size on taper side of the crankshaft?then who can repair the thread?
regards
joe
Re: thread size on crankshaft
Posted: Wed Mar 14, 2012 2:11 pm
by Toddy
Re: thread size on crankshaft
Posted: Wed Mar 14, 2012 2:14 pm
by gaz_powell
m12 x 1mm pitch lefthand thread
depends how bad the threads are - can you get away with a thread file ?
Re: thread size on crankshaft
Posted: Wed Mar 14, 2012 7:48 pm
by joespeed
the flywheel took some pulling off and 'mushroomed' the end of the threads,not had this for a long time!
thanks mr todd,got one ordered
had your neighbour 'mr skipsea' called in for tea this afternoon!
thanks for your assistance.
regards
joe
Re: thread size on crankshaft
Posted: Wed Mar 14, 2012 8:01 pm
by Toddy
joespeed wrote:the flywheel took some pulling off and 'mushroomed' the end of the threads,not had this for a long time!
thanks mr todd,got one ordered
had your neighbour 'mr skipsea' called in for tea this afternoon!
thanks for your assistance.
regards
joe
No probs Joe he likes his tea does Mr Skipsey I had him at ours friday night showin me his van
Re: thread size on crankshaft
Posted: Wed Mar 14, 2012 8:16 pm
by joespeed
Toddy wrote:joespeed wrote:the flywheel took some pulling off and 'mushroomed' the end of the threads,not had this for a long time!
thanks mr todd,got one ordered
had your neighbour 'mr skipsea' called in for tea this afternoon!
thanks for your assistance.
regards
joe
No probs Joe he likes his tea does Mr Skipsey I had him at ours friday night showin me his van
mmmm,nice very nice van,got some nice ice! and central locking system!lol.