thread size on crankshaft

[joespeed]

can anyone tell me the thread size on taper side of the crankshaft?then who can repair the thread?
regards
joe

[Toddy]

Tells you on here mate

http://www.forums.ilambretta.com/viewto ... 3F#p241104

[gaz_powell]

m12 x 1mm pitch lefthand thread

depends how bad the threads are - can you get away with a thread file ?

[joespeed]

the flywheel took some pulling off and 'mushroomed' the end of the threads,not had this for a long time!
thanks mr todd,got one ordered
had your neighbour 'mr skipsea' called in for tea this afternoon!
thanks for your assistance.
regards
joe

[Toddy]

the flywheel took some pulling off and 'mushroomed' the end of the threads,not had this for a long time!
thanks mr todd,got one ordered
had your neighbour 'mr skipsea' called in for tea this afternoon!
thanks for your assistance.
regards
joe

No probs Joe he likes his tea does Mr Skipsey I had him at ours friday night showin me his van

[joespeed]

the flywheel took some pulling off and 'mushroomed' the end of the threads,not had this for a long time!
thanks mr todd,got one ordered
had your neighbour 'mr skipsea' called in for tea this afternoon!
thanks for your assistance.
regards
joe

No probs Joe he likes his tea does Mr Skipsey I had him at ours friday night showin me his van

mmmm,nice very nice van,got some nice ice! and central locking system!lol.